- 1
- Unit/Units
Ultrasonic Doppler Flow Meter for Accurate Flow Measurement DFM 5.1
- Monitors, Displays, Totalizes and Controls from Outside a Pipe
- Ideal for full pipes and any liquid containing gas bubbles or solids larger than 100 microns and in concentrations greater than 75 ppm.
- The DFM 5.1 flow sensor installs without cutting the pipe. It takes just a few minutes to mount on the outside of any pipe.
- Calibration is easy with the built-in, 5-button keypad.
Special Features
- Digital processing system tracks flow signals accurately and auto-zeroes with signal loss
- Noise suppression circuitry filters “dirty” power and electrical interference from most VFD's
- Automatically converts between measurement units (e.g. gallons or liters)
- Calibration data and Totalizer values are stored automatically during power interruptions
- Output “simulation” function simplifies calibration of remote devices (e.g. chart recorders or controllers)
- Self-tunes to Sensor cable length
- Benefits of Non-Contacting Flow Measurement
- No Contact means no maintenance, no sensor fouling, no obstruction to flow, no pressure drop, no corrosion and no pipe cutting or drilling for installation.
Designed for:
- Raw Sewage
- Treated wastewater
- Viscous liquids
- Chemicals and Acids
- Sludge and Slurries
- Solvents
- Pulp stock
- Food products
- Lubricating Oils
- Crude Oil
- Cooling Water
Technical Specifications | |
Flow Rate Range | ± 0.1 to 40ft/sec (± 0.03 to 12.2 m/sec) |
Pipe Size | Any pipe from ½" to 180" (12.7 mm to 4.5 m) |
Accuracy | ±2% of reading or 0.05 ft/sec (0.015 m/sec). Requires solids or bubbles minimum size of 100 microns, minimum concentration 75 ppm. Repeatability: ±0.1%, Linearity ±0.5% |
Display | White, backlit matrix - displays flow rate, relay states, 16-digit totalizer, operating mode and calibration menu |
Calibration | built-in 5-key calibrator with English, French or Spanish language selection |
Power Input | 100-240 50-60Hz, 5 Watts maximum (with standard features) |
Output | Isolated 4-20mA (1000 ohm load max.) |
Control Relays | Qty 2, rated 5 amp SPDT, programmable flow alarm and/or proportional pulse |
Electronics Operating Temperature | -10° to 140°F (-23° to 60°C) |
Electrical Surge Protection | Sensor, 4-20mA output and AC power input |
- All India
D - 998, First Floor, Palam Extn., Sector-7, New Delhi, Delhi, 110077, India
Phone :65151223/45613132